![background image](http://html1.mh-extra.com/html/elecro-engineering/hr-30-b/hr-30-b_installation-and-operating-manual_2378724008.webp)
8
Fig. 7
All factory unions are made from ABS plastic, when gluing connections to an ABS pipe an ABS cement
must be used or when using a PVC pipe, a Transition cement must be used (See Fig. 7).
There is no need to use mastic or PTFE tape to connect unions to the device, use the O-rings provided to
put in the groove on the end of the Manifold Assembly.
NOTE: Be sure to apply the glue evenly and to all surfaces that will be in contact to reduce the
risk of leakage.
3.6 Electrical connection
WARNINGS:
•
This device must be installed by a qualified Electrician following the
instructions provided in this manual. The manufacturer will not be liable
for any issues caused by poor or improper installation.
•
Any alterations made to the unit (unless stated) will affect the warranty.
This also applies if components are changed for non-standard
components acquired anywhere other than direct from the manufacturer.
•
Incorrect installation may result in serious damage to property/persons.
•
The device must be installed in accordance with the country/regional
requirements and regulations and an Electrical Installation Certificate
must be provided on completion of the installation.
•
The power supply must be fitted with a 30mA RCD.
•
Never look directly at an illuminated UV lamp.
WARNINGS:
•
This device must be installed by a qualified Electrician following the
instructions provided in this manual. The manufacturer will not be liable
for any issues caused by poor or improper installation.
•
Any alterations made to the unit (unless stated) will affect the warranty.
This also applies if components are changed for non-standard
components acquired anywhere other than direct from the manufacturer.
•
Incorrect installation may result in serious damage to property/persons.
•
The device must be installed in accordance with the country/regional
requirements and regulations and an Electrical Installation Certificate
must be provided on completion of the installation.
•
The power supply must be fitted with a 30mA RCD.
•
Never look directly at an illuminated UV lamp.