10
2.6 CHANGING DISPLAY LANGUAGE
Your instrument is configured to operate in one of six languages - English, Français, Deutsch, Italiano,
Español or Nederlands. Usually it is set to the language most relevant to the country of supply, but it can be
changed to another, if preferred.
To prevent accidental change, the language is set by means of internal dip-switches. To change language,
follow the instructions below:
1. Ensure the charger is not plugged in to the gauge.
2. Remove the four crosshead screws from the bottom of the case.
3. Slide the bottom of the case off; the case is a tight fit and will require gentle rocking from side to side to
remove.
4. Locate the bank of four dip-switches (Figure 4) located by the mounting pillar at the front right corner of
the central PCB.
Op_402 TMA-0244 Issue 02.fm Page 10 Friday, February 9, 2007 12:01 PM
