8
G
ETTING
STARTED
R
The
temperature units
selection screen will appear:
Using the [UP] or [DOWN] buttons, select the temperature units, Celsius or Fahrenheit. Press
[ENTER] to confirm your selection.
The
mode
selection screen will appear:
Using the [UP] or [DOWN] buttons, select the required mode, Printer or Computer. Press [ENTER]
to confirm your selection.
The
set clock
screen will appear:
The day of the week flashes.
Use the [UP] or [DOWN] buttons to change it, if necessary. Press [ENTER] to confirm your
selection.
The first digit of the date flashes.
Use the [UP] or [DOWN] buttons to change it, if necessary. Press [ENTER] to confirm your
selection.
And so on, until all date and time values are correct.
The presentation screen will appear for two seconds and immediately afterwards the data screen
will be displayed.
If the mode was changed (from Printer to Computer or vice versa), switch off the Viscometer and
then switch on again.
Temperature Units
Celsius
Computer mode
Set Clock
Tuesday
(day)
15-11-05
(dd-mm-yy)
11:14:05
(hh:mm:ss)
2300_TMA_0377_00_01.book Page 8 Thursday, March 29, 2007 1:32 PM
