menu item
(english/French/german/Spanish)
Function
Exit / Quit / Verl / Sali
Move to a higher level menu (
◄
or
►
).
SetuP / SetuP / SetuP /configuracion
Enter the submenu by pressing
►.
CVBS1
Enable CVBS1 input, (not used).
CVBS2
Enable CVBS2 input, (not used, unavailable).
S_Video
Enable S-Video input, (not used).
VGA
Enable VGA input.
DVI-D
EnableDVI input, (not used).
Signal_in & Play
Select the signal input which will be monitored for the
presence of signal for the automatic turn–on function.
Hotkey define
Unused setting.
Language / Langue / Sprache / Idioma
Language for menu and OSD (on-screen display)
Exit / Quitter/ Verlassen / Salir
Move to a higher level menu (
◄
or
►
).
Exit / Quitter / Verlassen / Salir
Leave menu (press
◄
or
►
).
Working with menus
Display setup menu is brought up by pointing the remote control and pressing the MENU button on the remote
control. You can navigate between individual menu items by pressing MENU. It is only possible to move just
one item down each time you press button, after the last item is reached you are moved to the first item.
Menu items which do not have the indication of the currently set value on the right side of the menu line can
be activated by pressing the button
►
on the remote control.
Settings in the menu which have the indication of the currently set value on the right side of the menu line
can be adjusted by pressing the
◄
and
►
buttons on the remote control.
Menu items that are written in capital letters (except for Spanish and Korean versions of the menu) represent
a submenu in which you enter by pressing the button
►
on the remote control.
Switching the display brightness
Display brightness can be easily switched outside menu by pressing the “DIMMER” button between three modes:
Normal - normal brightness, Light - increased brightness (brighter display), Dark - reduced brightness (darker
display). Changing the display brightness is indicated by displaying corresponding word on the screen.
connecting to a comPuter anD conFiguration
Uniq Display connects to a computer through a standard 15 pin VGA cable. If Uniq Display has a touch panel
installed, it must be connected to the USB port of your PC with a USB A-A cable.
To setup the Uniq Display correctly, you need to set the display resolution for Uniq Display in your operating
system to 1024 x 768 pixels
In order to control the computer using Uniq Display’s touch panel, after connecting the USB cable it is
necessary to install and calibrate the drivers supplied on the CD. Drivers can also be downloaded from the
website www.elcom.e
. Driver installation and calibration is described in the following chapters.
24
Using the device
&/(-*4)