4
Big One Xtreme II_1.0_ENG.docx
Elaut NV
SYMBOLS USED
The following marking conventions are used in this manual to draw attention to specific
topics or actions:
Warns of a situation that could result in serious physical injury and/or may
cause material damage, if one does not follow the safety instructions.
Warns of a situation that could result in minor or moderate physical injury
and/or may cause material damage, if one does not follow the safety
instructions.
Provides additional information that is helpful to perform a task or to
avoid problems.
This is the CE logo, which indicates that the product meets the legal
requirements.
The ENEC symbol is an addition to the CE logo relating to electronic
products that are introduced to the European market.
The ENEC symbol is certified by a third party only, independently of the
manufacturer. It indicates that the machine and machine location are safe
as referred to in the corresponding European directive.
The symbol on the material, the accessories or packaging indicates that
this machine should not be treated as domestic waste.
WARRANTY
All electrical and mechanical parts of the machine
–
if used under normal operating
conditions
–
are covered by a one-year warranty from the original purchase date. Any
defective component will be replaced. However, our responsibility is limited exclusively to
the replacement of the defective component ex works; shipping costs cannot be attributed
to Elaut NV. No right of indemnity or reimbursement can be claimed.
LIABILITY
Elaut NV is not liable for any damages caused by failure to comply with the installation
instructions in accordance with the legislation in your country.
