Elaut NV
Big One Xtreme II_1.0_ENG.docx
11
UNPACKING AND INSTALLING THE AMUSEMENT MACHINE
Gather the equipment to assemble the Big One Xtreme II amusement machine and consult
the installation instructions before starting the installation.
•
Make sure there are no obstacles around the machine and that it is
installed on a flat surface.
•
Do not expose the machine to moisture or high humidity.
SERVICE
The machine may only be
repaired by qualified persons
:
Attention :
Watch out for the moving claw when entering the machine for any reason !
The
gantry
(attraction mode ON) can start moving.
The claw can cause serious injuries !
Switch OFF
the machine for cleaning, maintenance or service.
OPERATION
The following preparations have to be made, before the machine can be put into operation.
The claw power can be set automatically or manually, see below for more information.
AUTOMATIC SETUP (AUTOMATIC CLAW O N)
Choosing the automatic mode is factory recommended as the claw power will be adjusted automatically if necessary during
the game to stabilize the payout of the machine
Step 1 : Set the price
see Quick Start p. 20
Insert the correct purchase price of the product in the
"Product cost" field.
Than insert the vending price (= how much the product
should bring in) in the “Est. price out” field.
As a result of these 2 settings, the desired payout
percentage will be calculated.
) 90
Once this is done, select “S” to restart the game
, so the
payout regulator can start with the new values.
