4. Error message
(1) ” Error W001: PC can not connect with writer.”
Reason: DWTR software can not detect the writer.
Solution:
1.To check the power of the writer.
2.To check the printer cable between DWTR and PC.
3.To check if the status of print port is normal in PC BIOS.
4.To turn off and turn on the writer power.
5.To check again with another PC, if the problem still exists.
6.To call ELAN.
(2) ” Error W002: The file [file name] can not be opened!!”
Reason: The file can not be found.
Solution: To check whether the file exists or not.
(3) ” Error W003: The file [file name] can not be created.”
Reason: The file can not be created.
Solution: To check whether the disk is full or not and whether the system is affected by
virus or not.
(4) ” Error W004: The source window is found.”
Reason: A source window already exists.
Solution: To close the present source window.
(5) ” Error W005: The configure file is error.”
Reason: The contents of the initial file are not correct.
Solution: Please install DWTR window software again.
(6) ” Error W006:The file [file name] must be in CDS format.”
Reason: The format of file must follow the rules of CDS file.
Solution: Please recompile the source file.
(7) ” Warning W007: The ROM size %XH is not same as CDS code size %XH.”
Reason: The size of a selected microcontroller dose not fit with that of a present CDS file.
Solution: Please check the selected microcontroller again.
(8) ” Warning W008:The CDS code size %XH is over the ROM size %XH.”
Reason: The size of a selected CDS file is larger than that of the present microcontroller.
Solution: Please check the selected microcontroller again.
(9) ” Warning W009: The CDS code was created by [micro controller name], it is not the
same as [micro controller name].”
Reason: The current selected microcontroller is not the same as the microcontroller which
produces the CDS file.
Solution: To check a selected microcontroller again.
(10) ” Error W010: The source file is not opened.”
24
