All disclosures, notices and warranty conditions are being written on the back of the box.
Released on 11
th
of January, 2011.
Installation and mounting manual for EK-RAM Dominator water block
This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at
Before installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.
The barb hose fittings require only a small amount of force to screw them in; otherwise the high flow fittings might break. These fittings do not need to be tightened with much force because the
liquid seal is made using o-rings.
STEP 1: GENERAL INFORMATION.
Sample picture of Corsair Dominator GT memory module
STEP 2: REMOVING THE STOCK COOLER.
STEP 3: CLEANING THE SURFACES
Using the encased allen key please remove all three encircled screws in order to remove the red
aluminum heatsink. All heatsink assembly screws should be removed. Keep the two out of three
original 3-32 screws as you will need them later.
CLEANING THE MEMORY MODULES STOCK HEAT SINK ASSEMBLY.
Carefully detach the original heat sink after removing all fasteners securing
it to the aluminum cooler assembly. Wipe off the remains (by using non–
abrasive cloth or Q-tip, as shown on sample photo) of the original thermal
pads until the heatsink assembly is completely clean. EKWB does not
recommend using any liquids for removing paste.
STEP 4: INSTALLING THE MEMORY MODULES
STEP 5: APPLYING THERMAL COMPOUND
Please install all of your Corsair Dominator GT memory modules
into the motherboard DIMM slots, one by one.
Apply thermal compound: lightly coat the top of the DIMM modules with - for example Arctic Cooling MX2
™, MX3 ™ or MX4 ™ - thermal compound. Follow this link:
http://www.arctic-cooling.com/catalog/images/install_mx2_retail.pdf
for detailed instructions. EKWB
recommends to apply thermal grease in line form due to the specific design of this water block (see sample
picture). Avoid applying the paste into the threaded openings!
STEP 6: PLACING BLOCK ON DIMM MODULES
STEP 7: ATTACHING BLOCK TO DIMM MODULES.
During this process please make sure you align holes on PCB with holes on
block.
By using 3-32 inch allen key screw in the original 3-32 screws provided with every Corsair
Dominator memory module. EKWB recommends start screwing the other most screws and
continue inwards. Do not tighten the screw completely until you have aligned all memory modules
as straight as possible.
Use the two original 3-32inch
screws on each module!
Allen key 2.38
(3-32 inch)
