- 7 -
PLACING THE BLOCK ON TO MOTHERBOARD
Place the EK-Quantum Momentum ROG Crosshair VIII Hero
Monoblock series water block gently to the motherboard or vice
versa (as shown on the photo below). Make sure that mounting holes
are aligned.
ATTACHING BLOCK ON THE MOTHERBOARD
STEP 1
Prior to fastening the screws please make sure the mounting holes
on the motherboard’s circuit board are aligned with the water block.
Mosfet part:
Use four (4) M2,5x5 AX1 screws with PVC washers.
Tighten the screws evenly. Do not use excessive force when
tightening the screws!
CPU part:
Use four (4) M3x10 DIN7984 with screws. Tighten the
screws using enclosed 2 mm Allen key.
STEP 1
M2.5 PVC
washers
M3x10 Screws
M2.5x5 Screws
AM4 Backplate
AM4 Backplate
Insulator