- 8 -
CONNECTING THE PUMP
STEP 1
The EK-DDC 3.2 PWM has two connectors:
1. 4-pin Molex:
It must be connected directly to your PSU at all
times as it is used to power the pump.
2. 4-pin PWM fan:
It can be connected to your motherboard’s CPU_
Fan or designated water pump header. It can also be connected to
a controller. This cable is used to control and report the rotational
speed of the pump. If it’s not connected, the pump will run at
maximum speed (100% PWM).
STEP 1
4-pin molex
connector
TESTING THE LOOP
To make sure the installation of EK components was successful, we
recommend you perform a leak test for 24 hours.
When your loop is complete and filled with coolant, connect the
pump to a PSU outside of your system. Do not connect power to
any of the other components. Turn on the PSU and let the pump
run continuously. It is normal for the coolant level to drop during this
process as air collects in the distribution plate.
Inspect all parts of the loop, and in the eventuality that coolant leaks,
fix the issue and repeat the testing process. Ensure that all hardware is
dry before the system is powered on in order to prevent any damage.
4-pin PWM fan
connector
