/ 15 /
STEP 1
STEP 2
Intel® Socket
Mounting Plate
AMD® Socket
Mounting Plate
M4x14
Screws
Orientation of the
Copper Base
STEP 2
Replace the Intel® factory installed mounting plate with AMD® one.
You will feel the mounting plate locking into the position when placed
correctly onto the top.
Reseat the O-ring gasket (57x2,2mm) into the gap between the
mounting plate and the water block top.
Be careful that the orientation of the copper base is as
shown on the picture
Reinstall the M4x14 screws and tighten them using 2,5mm Allen key
to screw them in the clockwise direction.
AMD® SOCKET MOTHERBOARDS
STEP 1
Replacing the mounting plate:
Place the water block on an even surface and remove the four M4x14
DIN 7991 screws attaching the copper base to the top using 2,5mm
Allen key in counter-clockwise direction.
