- 7 -
For this step, you will need:
For this step, you will need:
Phillips Head Screwdriver
Phillips Head Screwdriver
PREPARING THE MOTHERBOARD
STEP 1
Important! Before starting, make sure to have a clean, flat
surface to work on. It is recommended that you put foam
or soft material to lay a motherboard and water block on.
STEP 1
First, remove the six (6) M2 x 2.5 screws shown in the image.
STEP 2
Rotate the motherboard and remove an additional two (2) M2 x 2.5
screws. After removing the screws, detach the original I/O Fan Cover.
Save the screws and cover for later use.
STEP 2
SCREW
M2 x 2.5
SCREW M2 x 2.5
ORIGINAL I/O FAN COVER