ekwb 3831109848616, User Manual, Page: 9 / 13

- 9 -
INSTALLING THE WATER BLOCK
STEP 1
PLACING THE BLOCK ON THE GRAPHICS CARD
This procedure is the same for all full-cover water blocks. Carefully
position the water block with preinstalled standoffs on the graphics
card. During this process, make sure you have aligned mounting
holes of the PCB with holes of the water block.
Pay attention not to use too much force when pressing
the block down to the PCB since chip dies are prone
to cracking.
STEP 1
STEP 2
STEP 2
Make sure that three (3) the self-adhesive M2,5 plastic washers are
in place as shown in picture.
Pay attention to the front area, where I/O ports are, those
metal springs may get in the way when inserting, holes on
PCB and block needs to be perfectly aligned!