- 8 -
REMOVING THE STOCK COOLER
STEP 1
Remove all encircled screws. There are three (3) screws and
one (1) standoff on the back of the motherboard that need to be
removed before you can take off the factory-installed MOSFET
cooling solution.
STEP 1
Stock Cooler
Screws
STEP 2
STEP 2
After removing the standoff and screws, carefully detach the stock
cooler and pre-applied thermal pads. EK provides replacement
thermal pads with the water block (see Chapter: Cutting and Placing
Thermal Pads).
Standoff