- 9 -
INSTALLATION OF FITTINGS AND TUBING
Screw in two male G1/4 threaded fittings. Attach the liquid cooling
tubes and connect the water-block(s) into the cooling loop.
EKWB
recommends using EK- fittings with the EK-Vector series water
blocks.
If you are using barb fittings please add hose clamps or an
appropriate substitute to ensure that the tubes are firmly secured.
You can configure any port as an inlet or outlet. Do not forget to plug
all remaining ports with the enclosed EK-Plug G1/4 or equivalents.
CAUTION:
If using fittings or plugs not recommending by EK take
special care to check the length of the male G1/4 threads. 5 mm is
the maximum allowed G1/4 thread length!
Tubing
EK-Fitting
EK-Plug G1/4
CONNECTING THE RGB LED STRIP (optional)
STEP 1
Plug the 4-pin connector from the water blocks
RGB LED
into the
RGB HEADER
on your motherboard. The LED will work correctly if
the pin layout on the header is:
+12V G R B
.
Please ensure that the arrow indicated on the connector is
aligned with the +12V pin as indicated on your motherboard.
Failure to do so, will damage your motherboard or LED strip.
STEP 1
RGB Header
