EKOM DK50 2x4VR/110/M, User Manual

Page: 43 / 168

PRODUCT MAINTENANCE
09/2020 43 NP-DK50 2x4VR 110-AD-A-1_09-2020

ESC+▲– “OPERATING TIME” screen
- information on operating hours: TOTAL,
RUN, STAND BY, time remaining to the next
service interval and value of the defined
service interval
- TOTAL HRS
– total time the dryer has been
energised
- RUN HRS
– total dryer cycling time
- STAND.HRS
– total time in STAND BY mode
- TIME-to-MT
– time remaining to the next
service interval
- SERV.INTER
– value of the defined service
interval

ESC+► (press and hold for 10 seconds) – to configure a new service interval once a service
operation is complete (see above
– Configuration of a new service interval).
18.5. Condensate drain
Open the drain valve carefully and slowly. If the drain valve is opened too much,
it is accompanied by high noise level and uncontrolled jet of the accumulated
condensate.
A wet floor resulting from overflow from the vessel poses a slip hazard.
Condensate from compressors with air
dryers is automatically drained into a
vessel to collect condensate.

Monitor the level in the vessel
using the markings (depending on
the volume of the vessel), and
empty at least once a day.
Fig. 21: Check of the condensate collection vessel
Before the following checks it is required:

For compressor variant with cabinet
– unlock the door lock and open the cabinet door.