10
Chapter 1 Introduction
Chapter 1 Introduction
Thank you very much for choosing an EIZO color LCD monitor.
1-1. Features
• 31.1 inches
• Wide-gamut panel
*1 Displayed image colors may appear to have a different tint than sRGB-enabled monitors due to the
different color gamut.
• Supports to the resolution of 8M pixels (4096 × 2160 dots)
• Uses high-contrast panel (1450:1).
Enables the display of sharp images.
• Applicable to DisplayPort (applicable to 8 bit or 10 bit, not applicable to audio signals)
• The “PbyP (Picture by Picture)” function enables the display of two signals at the same time.
A bezel-less widescreen offers less strain on the eyes and higher work efficiency compared to having two
monitors side by side.
•
The Hybrid Gamma function automatically identifies the display area for the monochrome and color
images on the same screen, and displays each set status.
*2
The identification may fail depending on the displayed image. The software to be used needs to be
verified. For validation, refer to the Installation Manual (on the CD-ROM).
• The RadiCS SelfQC function and the built-in Integrated Front Sensor allow the user to perform the
calibration and Grayscale Check for the monitor independently.
Refer to the Installation Manual (on the CD-ROM).
• The CAL Switch function allows the user to select the display mode optimum to the displayed
image.
Refer to the Installation Manual (on the CD-ROM).
• Selectable DICOM (page 22) Part 14 complied screen.
•
The quality control software “RadiCS LE” used to calibrate the monitor and to manage the history is
included.
See “1-3. EIZO LCD Utility Disk” (page 11).
• The software “ScreenManager Pro for Medical” to adjust the screen using the mouse and keyboard
is included
See “1-3. EIZO LCD Utility Disk” (page 11).
• Power saving function
This product is equipped with power saving function.
- 0 W power consumption when the main power is off
Equipped with main power switch.
When the monitor is not required, the power supply can be shut off using the main power switch
- Presence Sensor
The sensor on the front side of the monitor detects the movement of a person. When a person moves
away from the monitor, the monitor shifts to the power saving mode automatically and does not display
the images on the screen. Therefore, the function reduces the power consumption. The sensitivity and
time until the power saving mode is activated can be set according to the monitor usage environment and
movement of the user.
Refer to the Installation Manual (on the CD-ROM).
• Space-saving thinner and lighter design
• Long service life LED backlight LCD panel
• Built-in ambient light sensor
Depending on the environment, the sensor sometimes indicates different values from those measured by a
stand-alone illuminance meter.
The usage of this sensor requires the quality control software “RadiCS/RadiCS LE” and the measurement is
always triggered by the user’s operation in the corresponding menu.
For further details about the measured value and how to execute the measurement, refer to the RadiCS/
RadiCS LE User’s Manual (on the CD-ROM).
•
Displays HDCP (High-bandwidth Digital Content Protection) protected contents (DisplayPort only).
