22
Chapter 5 Configuring Monitor Settings
5-8. Enabling or Disabling DisplayPort Communication
in Power Saving Mode
Connecting a PC to the DisplayPort connector enables DisplayPort communication, and thus consumes
high power even in the power saving mode. The communication can be disabled by setting “DP Power
Save” to “On”. This reduces power consumption in the power saving mode.
Attention
•
If "On" is selected, window and icon positions may shift when the monitor is powered back on or returned from the
power saving mode. In such cases, set this function to "Off".
Procedure
1. Select to turn off the monitor.
2. While touching the leftmost switch ( ), touch for more than two seconds to turn on the
monitor.
3. Select “DP Power Save” in “Administrator Settings”, then select .
4. Select “On” or “Off”, then select .
5. Select “Apply”, and then select .
5-9. Locking Operation Switches
Adjusted or set states can be made unchangeable.
Procedure
1.
Touch
to turn off the monitor.
2. While touching the leftmost switch ( ), touch for more than two seconds to turn on the monitor.
3. Select “Key Lock” in “Administrator Settings”, then select .
4. Select “Off”, “Menu”, or “All”, then select .
Setup item
Lockable switches
Off
None (All switches are enabled.)
Menu
Adjust or set using the Setting menu.
All
All switches except
5. Select “Apply”, and then select .
Note
•
After calibration is performed using RadiCS / RadiCS LE, "Menu" is selected.
