16
Chapter 3 SelfCalibration
●
SelfCalibration functions
Set the details for "SelfCalibration".
Function
Settings
Description
Execute
-
SelfCalibration can be executed manually
regardless of the schedule.
Note
• After selecting "Execute", warming up
(after the power to the monitor is switched
on, leaving the monitor on for a certain
period of time until the display becomes
stable) may be executed before the built-
in calibration sensor comes out.
S
ett
ings
Mode Settings
Standard Mode
On
Off
Switch between enabling/disabling
SelfCalibration in Standard Mode.
Advanced
Mode
10-
CAL
On
Off
Switch between enabling/disabling
SelfCalibration in Advanced Mode.
Schedule
Start time
Power Save
Immediately
Application
Off
Select the timing to execute SelfCalibration upon
reaching the time set in the schedule.
• "Power Save"
To be executed under any of the following
conditions.
-When the monitor is in "Power Save" mode
or power is off at the set time.
-The monitor shifts to the power saving
mode or the power is turned off when the
set time in the schedule is exceeded.
• "Immediately"
SelfCalibration is executed immediately at
the set time.
• "Application"
Execute SelfCalibration according to the
timing set using ColorNavigator Network. For
details on ColorNavigator Network, refer to
our web site
(
.
• "Off"
SelfCalibration is not executed.
Frequency
Daily
Weekly
Monthly
Quarterly
Biannually
Annually
Usage Time
Select the SelfCalibration execution cycle.
