Eikon AETHER RM1, User Manual

Page: 11 / 32

11
RM1BT BODYPACK TRANSMITTER
See FIG. 2 at page 25
20. ANTENNA
This is the transmitting antenna: do not force it, disconnect it or try to replace it with a different one.
21. LED POWER
when the power button is pressed, the LED lights up indicating that the transmitter is in operation.
22. DISPLAY LCD
The LCD display shows various information:
a) Frequency
b) RF level of the transmitter.
c) Audio Gain of the transmitter.
d) Charge level of the battery. Three segments show the state of charge as a percentage. When the
voltage drops below 1.8 Volts the segments are not visible, and the icon starts flashing indicating
that the transmitter is shutting down.
23. SET BUTTON
Press and hold this button for 1 seconds and you can access the BODYPACK SET UP. Using the set button,
you can scroll the available options.
24. UP BUTTON
Pressing this button after the SET button you can change the value of the option selected.
25. IR
This is the IR infrared sensor port to receive channel settings from the RM1 receiver. Bring the Bodypack
close to the IR port to the receiver’s and expose the sensor during the frequency sync procedure and to
transmit settings parameters.
26. BATTERIES INLETS
To access the battery compartment and the IR sensor, lightly press the side flaps indicated by a raised dash
on the cover and slide down the battery cover. When replacing the batteries respect always the polarity
marked inside the battery inlet.
27. ON-OFF BUTTON