INSTALLATION INSTRUCTIONS
VOL22-3C-XXK-U | VOL22-3CP-XXK-U
VOL24-5C-XXK-U | VOL24-5CP-XXK-U
SAFETY PRECAUTION:
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling parts, cuts/abrasions, and
other hazards read all warnings and instructions included with and on the fixture box and all fixture labels.
Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
Commercial installation, service and maintenance of luminaires should be performed by a qualified licensed electrician.
For the installation: If you are unsure about the installation or maintenance of the luminaires, consult a qualified licensed
electrician and check your local electrical code.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING: RISK OF FIRE OR ELECTRICAL SHOCK
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
Turn off the power when you perform any maintenance.
Verify that supply voltage is correct by comparing it with the luminaire label information.
All wiring connections should be capped with UL approved wire connectors.
CAUTION: RISK OF INJURY
Avoid direct eye exposure to the light source while it is on.
Account for small parts and destroy packing material, as these may be hazardous to children.
Risk of burns. Disconnect power and allow fixture to cool before changing bulb or handling fixture.
GREEN GROUND SCREW PROVIDED IN PROPER LOCATION. DO NOT RELOCATE.
MINIMUM 90
˚
C SUPPLY CONDUCTORS.
SPECIFICATIONS AND DIMENSIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
SUITABLE FOR DRY OR DAMP LOCATION, TYPE IC.
INSTALLATION:
ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
1. Bend out mounting tab 90 degrees on
each corner.
2. Use side cutters to adjust each tab to
height of T-grid.
3. Lay fixture into T-grid.
4. Bend tabs flush against T-grid in order
to clear corner for ceiling tile.
5. Use a #8×1/4” sheet metal screw
to fasten fixture to T-grid and use a
hanger wire to tie off appropriately in
accordance with local building codes
(screws and hanger wires supplied by
others).
6. Ensure that the wiring of the last fixture
in the row is properly terminated.Then
make all electrical connections to the
fixture. Attach the wiring access cover
plate.
EiKO Global, LLC • 23220 W. 84th St, Shawnee, KS 66227 • (P) 1-800-852-2217 • (F) 1-800-492-8975 • eiko.com
EiKO Canada • 81 King St, Barrie, Ontario L4N 6B5 • (P) 1-705-721-5189 • (F) 1-705-721-7855 • [email protected]
FIG. 1
FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 6
Black (Line)
White (Neutral)
Green (Grd)
Purple (Dim+)
Gr
ey (Dim-)
Blue (-)
Red (+)
LED DRIVER
Dimming Wire
to 0-10v IEC
compliant control
Lead wire to
LED load
120-277v
WIRING DIAGRAM
