—
12
—
DLP Projector — Owner’s Manual
Starting and Shutting down the Projector
Turn the Projector On
1.
Connect the power cord to the projector. Then connect the other end to a wall outlet.
The Power button on the built in keypad is illuminated.
Important:
Make sure that the Power switch is in the ON position.
2.
Turn on the connected devices.
3.
Turn on the projector by pressing “ ” on the remote control
or press “ ” on the built-in keypad. The Status LED is
Orange with a long blink.
The projector splash screen displays and connected
devices are detected.
4.
If more than one input device is connected, press the
Source
key on the remote control to select an
input source (HDMI1, HDMI2, DVI-D, VGA, HDBaseT, or 3G-SDI).
5.
The projector detects the source you selected and displays the image.
Turn the Projector Off
1.
Press “ ” on the built-in keypad or press “ ” on the remote control to turn off the projector. A warning
message will appear on the displayed image.
2.
Press “ ” on the built-in keypad or press “
” on the remote control again to confirm your selection. If
you do not press “ ” or “ ” again, the warning message will disappear after 10 seconds.
Caution:
Do not unplug the power cord until all of fans are stop–indicating the projector has cooled down.
