【
NOTICE
】
The mesh size of the shelf board is 14mm.
Do not clean the model smaller than 14mm, otherwise it
will fall into the cleaning component and cause damage
to the model and device.
【
NOTICE
】
It is recommended to use alcohol or IPA as
the cleaning solution,
Water (no add, eg. Soap, Hand sanitizer, Detergent ect.)
can be used for water-washed resin as the cleaning
solution.
Recycling of cleaning fluid
Taking IPA as the cleaning solution as an example. after
repeated cleaning and use, a large amount of resin will
dissolve into the IPA, resulting in a gradual decrease in
the cleaning effect.
The following methods are recommended to increase
the times of IPA can be used:
1.After took out the printing model for the printer,
simply soak the model with turbid alcohol, in order to
remove most of the resin on the surface of the model,
and then put it in the device for automatic cleaning,
which can increase the times of IPA use. There is a
sealed box in the package which can be used as a
pre-cleaning box before automatic cleaning, or other
larger-sized containers can be used as a pre-cleaning
tank. 2 pre-cleaning tanks to soak in sequence for better
effect.
-6-