Eibach 2021.312 Installation Instructions Download Page 1

 

D2606Rev1 

www.eibach.com

 

Page 1 of 2

 

 
 

Eibach Springs, Inc. 

 264 Mariah Circle 

 Corona, California 92879-1751 

 USA 

 Tech Support 800-222-8811 Ext 114

 

 
 
 
 
 

 
 
 
 
 
 
Kit Contents 

    

 

Description 

 

Part Number 

 

Qty 

 

 

REAR BAR 

Rear Bar  

2021.320HA 

 1 

Hardware kit 

 

 Bushing 

2021.3100 

 2 

  

 Tie Rod 

2021.3101 

 2 

  

 Bolt 

H13024745 

 2 

 

 Washer 

H50025100 

 4 

 

 Lock Nut 

H63074700 

 2 

 

 Lubricant 

AR.LUBRICANT 

 1 

 

DOCUMENTS 

Instructions 

2021.321INST 

 1 

Information Kit 

EPAK 

 1 

 

You have just purchased an ultra-high performance sway bar kit equipped with 
high performance poly-urethane bushings 

– which may cause some additional 

road noise and/or bushing noise- this is considered normal. 

 
Preparing the vehicle for Anti-Roll Kit Installation 

1.  A technician, certified in the suspension work and/or familiar with your particular vehicle, should 

perform the Installation of this kit.  A factory shop manual may be necessary for the installation of 
this kit. 

2.  Verify the individual Anti-Roll Bars and necessary hardware included in the 

Eibach

 Anti-Roll Kit is 

correct for your vehicle.  Use the Bill of Materials Listing above to verify all hardware.  If your vehicle 
did not come factory equipped with a rear anti-

roll bar, you will need to purchases the “clip nuts” from 

a local dealer to secure the rear bar to the lower control arms. 

3.  Raise the vehicle securely off the ground using a commercial car lift or jack stands.  

4. 

Never work on/or under a vehicle that is solely supported only by a “JACK"!! 

5.  If necessary, remove the wheels from the axles for better access. 
 

Rear Bar Installation 
Removing the factory Rear Anti-Roll Bar 

1.  Loosen and remove the stock middle bushing brackets (both sides).  

Do not discard these 

brackets, as they will be needed to re-install the 

Eibach

 Anti-Roll Bar.

 

2.  Loosen and remove the end links from the anti-roll bar arms (both sides).   
3.  Loosen and remove the end links from the lower control arm.  

Do not discard these nuts and 

bolts, as they will be needed to re-install the 

Eibach

 Anti-Roll Bar.

 

4.  Remove the stock anti-roll bar. 
 

Installation Instructions 

 

ANTI-ROLL KIT- 

#2021.312 

BMW 318i, 318is, E36, 4cyl., Exc. Cabrio & Compact  12/90><4/99 
BMW 318i, Cabrio, E36, 4cyl., 2/94><4/99 
BMW 325i, 2 & 4-door, E36, 6cyl., Exc. Cabrio  12/90><5/92 
BMW 325i, 328i, 2 & 4-door, E36, 6cyl., Exc. Cabrio  6/92><4/99 
BMW 325i, 328i, Cabrio, E36, 6cyl., 5/93><4/99 

 
 

Reviews: