Display and Controls
18
EFAS
2.3.1
Adjusting of the Activity
Following activities are indicated by the digital tachograph
EFAS:
Driving time (set automatically)
Working time
Availability
Rest time
Manual setting
•
As driver in stationary vehicle press the button
1
so
often, until the desired activity (
,
,
) appears in the
display. On this occasion, one should take care that
the button is not pressed too long, as this will eject the
card.
•
Press as co-driver (driver 2) the button
2
so often,
until the desired activity appears in the display.
Activity driver
1
Activity driver
2
Note
Do not forget to check the set activity after the journey end.
Automatic adjusting of the Activity
After the vehicle starts to move, the digital tachograph
EFAS switches after a short time automatically for the driver
to driving time
and for the co-driver to availability
. If the
vehicle stops, the digital tachograph EFAS toggles for the
driver automatically to working time
.
In addition to the above mentioned change-over of the
driver's activity, the digital tachograph EFAS takes back the
automatic switchover of driving time to working time again if
the vehicle stops for less than 2 minutes.
If the automatic switchover of the activity is activated after
ignition ON/OFF, the driver and/or the co-driver receives
the preset activity if the ignition is switched on or switched
off. This setting can be carried out with an inserted com-
pany card with the menu “Settings“, see "Automatic Setting
of Activities after Ignition OFF/ON" on page 59.
