Efka AB600A5015, Operating Manual

Page: 50 / 64

- AB600A5015 Parameter List
- 50 -
12 Parameterlist
12.1 Operator Level
The preset values indicated apply to mode 0 (Parameter 290 = 0).
For preset values applicable to other modes see table in chapter 11.1 »Preset Values Depending on Mode«.
Parameters Designation Unit Max Min Preset Ind.
002 c3
Number of stitches of cutter at seam begin Stitches 254 0 2
003 c4
Number of stitches of cutter at seam end
Stitches 254 0 2
004 LS Light barrier compensating stitches Stitches 254 0 7
005 LSF Number of stitches of the light barrier filter for knitted
fabrics
Stitches 254 0 1
006 LSn Number of light barrier seams 15 1 1
007 Stc Number of stitches for the seam with stitch counting Stitches 999 0 20
009 LS Light barrier On/Off 1 0 0
013 FA Thread trimmer On/Off 1 0 0
014 Fw Thread wiper On/Off 1 0 0
015 StS Stitch counting On/Off 1 0 0
017 SAb Stop for tape cutting at the seam end On/Off
(Function only when overlock mode is active).
1 0 0
018 UoS 0 =
Sequence “overlock mode with stop”
1 =
Sequence “overlock mode without automatic stop. When the
command “run” is given, the drive runs at the pre-selected
speed. With
pedal in pos. 0 or light barrier covered , the
program switches to the next start of a seam without issuing
signals M1/M2.
2 =
As with setting “1”. But with
pedal in pos. 0 signals M1/M2 will
be issued, and the program switches to the next start of a
seam.
3 =
As with setting “1”. But with
pedal -2 signals M1/M2 will be
issued, and the program switches to the next start of a seam.
Intermediate stop and sewing foot lifting with pedal in
pedal -1
is possible.
4 = If the light barrier is covered during the end count for chain
suction, the program switches immediately to the next start of a
seam. If the end count has been completed and the light barrier
remains uncovered, the drive stops.
5 = Tape cutting at the start of the seam with stop
5 0 0