34
Restoring functionality after service
Restoring functionality after service
To complete any service procedures performed on the Fiery X3eTY, reassemble the
Fiery X3eTY, reattach it to the print engine, and verify that it is working properly. To
verify the installation, check the external connections of the Fiery X3eTY to the
print engine and then to the network and/or USB port.
T
O
REASSEMBLE
AND
VERIFY
THE
F
IERY
X3
E
TY
1.
Reseat any cables, devices, DIMMs, or other parts of the Fiery X3eTY assembly that you
may have loosened or removed during inspection or service (see “Checking connections”
on page 12).
2.
Reattach the Fiery X3eTY to the print engine.
When connecting the interface cables between the Fiery X3eTY and the print engine, do
not interfere with the engine cable. To prevent jamming the engine cable against the
frame, route the interface cables underneath the engine cable.
3.
If you installed a new HDD, install system software according to the procedure in
“System software” on page 39.
A spare HDD is shipped without system software.
4.
Make sure the service switches are set for normal operation (both up). If necessary, shut
down the Fiery X3eTY and flip their position (you do not have to unplug the Fiery X3eTY
or the print engine).
5.
Before you leave the customer site, verify Fiery X3eTY operation as described in the
following flow diagram.
F
IGURE
N
Steps to verify the Fiery X3eTY
N
OTE
:
After power up, check the airflow of the fans to make sure air is blowing out the
top fan and not blowing out the bottom fan.
Power up and print test pages
(see page 35).
Check the Setup options
(see
Configuration and Setup
).
Connect the Fiery X3eTY to the network
and verify (see page 37).
N
OTE
:
If the Fiery X3eTY does not turn on
within a few seconds, press the Soft power
button on the connector panel.
