27
Installation and Service Guide: Printer Controller EB-34
Using the EB-34
•
FTP Log:
Lists jobs scanned on the copier and sent to the FTP site designated in the setup options. The log is
available only when Scan to FTP is enabled in Setup. For more information, see
Configuration and Setup
.
To print EB-34 pages from the copier touch panel
1
On the copier touch panel, press the
Home
button.
2
Press the
Fiery
icon.
3
Press the
Fiery
tab.
4
Press
Printable Info.
5
Press the name of the page you want to print.
Network Status LEDs
Two LEDs next to the Ethernet network port indicate the network speed. When data transfer occurs between the EB-
34 and the network, the appropriate LED(s) blink to indicate network activity.
About Configure
You can access Configure from Command WorkStation or WebTools, and you can find information about using it the
following ways:
•
When you access Configure from an Internet browser, in WebTools, on the Configure tab, click the
Help
icon.
•
When you access Configure from Command WorkStation, see
Command WorkStation Help
.
To access Configure from an Internet browser
1
Open an Internet browser and type the IP address of the EB-34.
2
In WebTools, on the Configure tab, click
Launch Configure
.
3
Log on with Administrator privileges.
Network link speed
LED 1
LED 2
10 Megabits/second
Off
Green
100 Megabits/second
Green
Green
1000 Megabits/second
Amber
Green
Caution:
The copier interface cable included with the EB-34 is a
crossover
Ethernet cable that connects to the
lower
(crossover) Ethernet port on the EB-34 connector panel. The network cable at the customer site is a
straight-through
Ethernet cable that connects to the
upper
(straight-through) Ethernet port on the EB-34
connector panel. The cables look similar, but are not interchangeable. Make sure that you connect the cables to
LED 2
LED 1
Ethernet network port
(Upper RJ-45)
