43
Installation and Service Guide: Color Controller E-45
Using the E-45
To shut down, restart, or reboot from the Fiery QuickTouch
Note:
Notify the network administrator before you remove the E-45 from the network.
1
Make sure that the E-45 is not receiving, processing, or printing any jobs.
If Printing appears on the Fiery QuickTouch, the E-45 is processing. You must wait until the system finishes and
reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches Idle before beginning the
shutdown procedure.
2
On the Fiery QuickTouch Home screen, tap the
Quick
options menu button.
3
Make a selection.
•
To restart or reboot the E-45, tap
Restart server
or
Reboot system
, respectively.
•
To shut down the E-45 immediately, tap
Shutdown system
.
Allow the system to shut down and power off or restart.
If you tapped
Restart server
, you may need to wait one minute or more for the server software to restart.
4
Before accessing internal components following a shutdown, make sure that all cables are disconnected from the back
of the E-45.
To shut down, restart, or reboot from the printer touch panel
Note:
Notify the site administrator before you remove the E-45 from the network.
1
Make sure that the E-45 is not receiving, processing, or printing any jobs.
If Printing appears on the Fiery QuickTouch, the E-45 is processing. You must wait until the system finishes and
reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches Idle before beginning the
shutdown procedure.
If the system has just finished processing, wait at least five seconds after the system reaches Idle before beginning the
shutdown procedure.
2
Press the
Fiery
tab.
3
Press
Restart Fiery
.