26
Installation and Service Guide: Color Controller E-45
Installing Hardware
3
Select
Configure IP Address
, and select IP
Address
,
DNS
,
Subnet Mask
,
WINS
, and
Default Gateway
, as necessary.
4
Save the settings and exit.
Enabling the power synchronization
During the installation, enable the power synchronization feature by using the OFF/ON switch on the printer interface
board, and the USB power cable included in the accessory kit. The default switch position is OFF.
When you enable power synchronization, the E-45 synchronizes power with the printer’s main power off/on status. If the
printer powers off, the E-45 receives signals from the printer through the printer interface (Data Transfer Unit) cables
connected to the printer interface board, and automatically starts the shutdown process. If the E-45 receives the startup
signals from the printer, the E-45 automatically powers on and begins the startup sequence.
To enable the power synchronization feature at the E-45
1
Shut down the E-45 (see
) and the printer.
Important:
After the power synchronization is enabled, make sure to control the E-45 power using the printer.
A
printer connector panel
B
E-45 connector panel
1
Type A USB ports
3
Type B USB port on the main printer interface board
2
USB cable
4
Switch on the main printer interface board:
OFF position (default)