S
ETTING
UP
FROM
THE
C
OPIER
C
ONTROL
P
ANEL
31
Contact Info
Specify the contact information for people who provide support for the E-42B and
copier/printer.
Jobs Setup
PostScript
PostScript Setup menus allow you to set printing defaults for jobs sent to the E-42B. When a
user prints a job from the printer driver, the user can make a specific setting for most print
options on a job-by-job basis, and this setting is applied to the job. However, users who send
jobs without a printer driver (for example, from UNIX or DOS command lines) cannot
specify a setting and therefore must rely on the defaults that you set in Setup. For information
about these defaults, see
Job Preview & Printed Jobs
Preview While Processing
Choose whether to display a preview thumbnail in Command WorkStation while a job is
being processed. The preview thumbnail is displayed in the Processing section of the Activity
Monitor.
Enable Printed Queue
If you enable this option, you enable the Printed queue, which is a storage location on the
E-42B hard disk for recent jobs that were printed from the Print queue. Users do not print to
the Printed queue. However, users with Administrator or Operator access to the job
management tools can reprint jobs from the Printed queue without resending them to the
E-42B. If you do not enable the Printed queue, jobs are deleted from the E-42B hard disk
immediately after they are printed.
Jobs Saved in Printed Queue
1-99,
10
If you enabled the Printed queue, specify the number of jobs to store in the Printed queue.
Jobs in the Printed queue take up space on the E-42B hard disk. If disk space is low, specify a
smaller number of saved jobs.
Enable Mismatch Action
Choose whether the E-42B takes particular action if the job cannot print because of missing
resources.
Mismatch Timeout
0-999 (5)
If you enabled Enable Mismatch Action, specify how long (in seconds) the E-42B waits before
it determines that a job is mismatched and therefore should be canceled.
