S
ETTING
UP
FROM
THE
C
OPIER
C
ONTROL
P
ANEL
27
Setup options
When you perform E-42B Setup from the copier control panel, you configure the E-42B to
receive jobs over the network systems that are used at your site, including setting network
addresses and names to be used by computers, servers, and the E-42B when they
communicate with each other.
Before performing Setup, confirm that the E-42B is connected to an active network, because
the E-42B queries the network for zones, servers, and server-based queues. If you perform
Network Setup without a connected and functioning network, default settings are used that
may not meet your needs.
Configure options only for the network systems that are currently used at your site. If your
network requirements change, you can change Setup at any time. If the E-42B is configured
to enable more than one protocol, it automatically switches to the correct protocol when it
receives a print job.
The submenus and options appear in sequence. Default values, where applicable, are
underlined. Words shown in italics indicate a product- or site-specific value.
Server Name
Default server name
Enter a name for the E-42B (a maximum of 15 characters). This is the name by which the
E-42B appears on the network.
N
OTE
:
If you set up more than one E-42B, do not give them the same name.
Ethernet Speed
Auto, 10Mbps(10Mbps Half-Duplex), 100Mbps(100Mbps Half-Duplex), 10FD(10Mbps
Full-Duplex), 100FD(100Mbps Full-Duplex)
Choose the appropriate speed of the network. Choose Auto in any of these cases:
• The network speed is unknown.
• The network environment is mixed.
• The network uses 1Gbps.
Restart Fiery
Shuts down all E-42B activity in the correct manner and then restarts. The following
options are available from the submenu that appears:
Restart Fiery Service:
Resets the server software but does not reboot the entire system.
Network access to the E-42B is temporarily interrupted and all currently processing jobs are
aborted and may be lost.
Restart System:
Shuts down and then reboots the E-42B.
Shut Down:
Shuts down all E-42B activity properly.
