I
NSTALLING
H
ARDWARE
22
Configuring a static IP address for the E-42
If the customer requires the E-42 to be configured with a static IP address (for example, in a
non-DHCP network environment), obtain a valid static IP address from the network
administrator and configure the E-42 as described in the following procedure.
T
O
CONFIGURE
A
STATIC
IP
ADDRESS
FOR
THE
E-42
1 Press the “fierydriven®” button on the copier/printer and make sure that Idle appears on the
copier/printer touch panel (see
).
2 Press the Fiery tab.
3 Press Setup.
4 On the Login screen, press Password. Enter Fiery.1. Press OK.
Type
Fiery.1
exactly as shown. The password is case-sensitive; for example,
fiery.1
will not
work.
5 On the Setup screen, do the following:
• Press WINS. If enabled (yellow), press Use WINS to disable this feature. Press Save.
• Press DNS. If enabled (yellow), press Get DNS address automatically to disable this
feature. Press Save.
• Press IP Address. Enter an IP address. Press Save.
• Press IPv4 Address. Press Manual Configuration.
6 On the Manual Configuration screen, do the following:
• In the IP Address field, enter an IPv4 address. Press OK.
• In the Subnet Mask field, enter a subnet mask IP address. Press OK.
• In the Default gateway field, enter a default gateway IP address. Press OK.
• When done, press Save. Press Go Back.
7 On the Setup screen, press Exit Setup.
8 Press Reboot Now.
