18
Installation and Service Guide: Color Controller E-36A
Installing Hardware
Checking the customer site
Before you install the E-36A, check site conditions and inform the customer of any installation requirements.
Figure 5:
Space requirements for the E-36A without optional furniture
Printer readiness
•
Is the printer configured for use with the E-36A? (For the proper settings, see the documentation that accompanies
the printer).
•
Is there a adequate space available near the printer for the E-36A and the optional Fiery NX One Station?
Make sure that adequate space is available for the E-36A and the optional Fiery NX One Station. Allow enough
space at the connector panel for the cables to route easily and at the side panel, so that the E-36A does not interfere
with use of or service to the printer (such as clearing a paper jam). You may need to move the printer away from the
wall so that the
interface connectors are accessible.
•
Does the printer require service or adjustments?
Print the printer Test Page before you install the E-36A.
If the image indicates that the printer needs adjustment, inform the customer. After
getting approval, complete the
necessary printer service.
Power
•
Is a dedicated, grounded electrical outlet for the E-36A available near the
printer?
Locate the grounded electrical outlet that will supply power to the E-36A. Do not run the E-36A and the printer on
the same circuit. If the customer has provided one, use a surge suppressor for the E-36A.
Network
•
Make sure that the network is available at the time set for installation.
1
20cm+ (8 in.)
4
Side panel
2
E-36A
5
Fiery Quick Touch display panel
3
Connector panel
6
Front panel
1
3
4
1
2
2
1
3
6
6
5
Top view
Left view
