document version: 1.0.0 - English
Instruction manual
14. Transporting your worker robot
When transporting the worker robot:
•
Always disable the worker robot by laying your hand on the middle of the front
screen (between the eyes of the robot) to stop it, take your hand of and repeat the
handling a second time for 3 seconds until you see OFF in the eyes for a few
seconds.
•
When transporting the worker robot by hand, hold it side handles (above the
wheels) with the mowing blade pointing away from you.
•
When transporting the worker robot in a vehicle, position and secure the worker
robot to prevent turnover, impact and damage. Fasten the machine using suitable
fastening materials (straps, ropes).
•
Secure components being transported (e.g. docking station, small components) to
prevent turnover, impact and damage.
A Note on Battery Transport
The battery inside this worker robot complies with the requirements set forth in UN-
Manual ST/SG/AC.10/11/ Rev.5/Part III, Subsection 38.3.
Commercial air, vessel and ground transportation of lithium ion cells and batteries
contained in equipment is regulated. The battery inside this worker robot is classified as a
UN 3481, Class 9, packaging group II product. Shipping it requires compliance with all
applicable shipping regulations. Check with the ground, vessel, air cargo or passenger
airline to determine if transport is prohibited or subject to restrictions or exemptions prior
to shipping or travel.
Normally, no further conditions have to be met by the user in order to transport this
worker robot by road to the operating site. Check and comply with any special regulations
that may apply to your situation.
The Toadi Order BV, Belgium
Original Instruction
Page of
33
47
