Simplified Installation of the
EESiFlo Portalok 7S Ultrasonic Flow Computer
Setup and Installation of the Portalok 7S Ultrasonic Flow Computer involves three simple steps.
Define the Parameters of the Pipe and Fluids (PAR on the main menu)
Select the Output Options (OPT on the main menu)
Enter the Measure Mode (MEA on the main menu)
Defining the Pipe and Fluid Parameters
>PAR<
1)
Plug the Transducer into the receptacle marked
Transducer
.
2)
Turn the instrument
ON
by pressing the
PWR
button
3)
Using the Arrow keys scroll to
PAR
(parameters) on the main menu and press
ENTER
.
4)
Enter the pipes
Outer Diameter
by using the Down arrow key to change the values and the right
arrow key to move to the next position
then press
ENTER.
Remember, this is the OD of the pipe not
the pipe size. For example a 2 inch pipe has an Outside Diameter of 2.375 inches.
5)
Next, enter the pipe
Wall Thickness
using the arrow keys then press
ENTER
6)
Select a
Pipe Material
using the arrow keys to scroll up and down through the available list then
press
ENTER
.
7)
Answer
YES
or
NO
to the prompt for
Lining
. If you answered
YES
, then enter the
Lining Type
(using the arrow keys) and then the
Lining Thickness
8)
Enter the internal
Roughness
of the pipe (this is an estimate, if unknown leave as default) then press
ENTER
9)
Using the arrow keys, select the
Medium
(Liquid Type) from the available list then press
ENTER
.
10)
Enter the approximate
Medium Temperature
then press
ENTER
.
11)
Enter
Additional cable
length (if no extension is used select 0) then press
ENTER
and you will
return to the main menu.
219 East Main Street
Mechanicsburg, PA
USA, 17055
Toll Free: 866-337-4356
Fax: (717) 697-2122
