EEC SE 7430, User Manual, Page: 98 / 106

90
and will not be able to generate output voltage or current.
RS?
Read Scanner Status command will respond with a value that identifies the number of scanners
installed or connected to the instrument. Values 0 – 4 will indicate if there are no scanners
connected, one Internal or External scanner, or if both an Internal and an External scanner are
connected.
LF?
Lists the file name of the memory loaded into active memory (RAM).
LFN?
Lists the memory number of the active memory file loaded into active memory (RAM).
LF <memory number>?
List the file name of any of the 50 memories.
LP?
Lists the prompt that is created for the selected step within active memory (RAM).
LP <step number>?
Lists the prompt that has been created for a particular step of the file within active memory
(RAM).
LS?
Lists all the parameters for the individual step that is currently selected. See the ADD command for
the list of parameters. A comma (,) will separate each parameter and will be preceded with the
step number.
LS <step number>?
Lists all the parameters for the individual step indicated by step number = 1-30. See the ADD
command for the list of parameters. A comma (,) will separate each parameter and will be
preceded with the step number.
8.4.7
IEEE 488.2 Common Commands
These commands are required by the IEEE-488.2 standard with the exception of *PSC, *PSC?.
Most of these commands are not available over the USB/RS-232 bus except for the *IDN?
command which can be used to retrieve the instrument identification information, and the four
status reporting commands *ESR?, *ESE, *ESE? and *STB?
COMMAND NAME DESCRIPTION
*IDN? Identification Query EEC, Model Number, Serial Number,
Firmware Revision
*RST Reset Command Resets SE series