EEC SE 7430, User Manual, Page: 87 / 106

79
8.4.3 File Editing Commands
The following commands are used to create or modify Test Setup Files.

Commands should be separated from parameters by a space.

If multiple parameters are entered, they should be separated by commas.
COMMAND DESCRIPTION VALUE
FL <memory number> File Load memory number = 001-200
FN nn,xxxx File Name nn=01-2000, xxxx=name
FD File Delete Current file in use
FD nn File Delete nn nn=1-200
FS File Save Current file in use
FSA nn,xxxx File Save As nn=1-200, xx=Name
FT? File Total
ST? Step Total
SS <step number> Step Select step
number step number = 1-200
SS? Step Select ?
SAA Step Add ACW test
SAD Step Add DCW test
SAD- Step Add DCW- test
SAI Step Add IR test
SAG Step Add GND test
SAC Step Add CONT test
ADD2 <n ,p1,p2,p3…> Add all parameters of
a test step n=test type, p=parameters
ADD3 <n ,p1,p2,p3…> Add all parameters of
a test step n=test type, p=parameters
SD Step Delete current
SD nn Step Delete nn nn=01-200
SP <prompt message> Step Prompt Create prompt message = Valid ASCII (1)
maximum 32 characters
SP Step Prompt Delete
LP? List Prompt
LP nn List Prompt current
(1) "Valid ASCII" is the character set that is available from the front panel LCD user interface.
Consisting of upper case alphabet (A-Z), numbers (0-9) and decimal point (.), asterisk (*), dash (-),
under bar (_), tilde (~) and space (SP).
FL <memory number>
Load a file by memory number from non-volatile memory into random access memory RAM.
FN < file name>
Creates a new file name for the active memory loaded into RAM.