Figure 3 Inlet-filter removal and replacement
1. Inlet adaptor
2. Inlet-filter
3. O-ring
1. Inlet adaptor
2. Inlet-filter
3. O-ring
6.6 Clean or replace the gas-ballast O-ring
Note:
The filter element is retained in its seating with adhesive, do not try to remove it.
Refer to
Figure: Gas-ballast O-ring removal and replacement on page 31
.
1.
Unscrew and remove the gas-ballast control.
2.
Remove the O-ring from the control.
3.
Wash the O-ring in a suitable cleaning solution. Replace the O-ring if it is damaged.
4.
Replace the O-ring carefully on its seat. Screw the gas-ballast control back into the
pump and reset to the required position.
Page 30
A37132880_F - Maintenance
Summary of Contents for A37104902
Page 43: ...Page 41 A37132880_F Service...
Page 44: ...edwardsvacuum com...
