PhaseTrakker
AP30
Cautions and Warnings
1
Cautions and Warnings
NOTICE
Before operating the AP30 system, thoroughly read, understand, and follow this
manual. Save this manual – do not delete or destroy.
CAUTION
The equipment covered in this manual should be used and serviced only by com-
petent personnel familiar with and following good work and safety practices.
This equipment is for use by such personnel, and the manual is not intended as a
substitute for adequate training and experience in safe procedures for this type
of equipment.
These instructions neither cover all the details or situations in equipment use, nor
do they provide for every possible contingency to be encountered in relation to
installation, operation, or maintenance. Should additional information and de-
tails be desired, or if situations arise that are not covered adequately for the
user’s purpose, the specifics should be referred to EDM International, Inc.
WARNING
On voltages above 300 V, the AP30 Hotstick Unit must be used in conjunction
with an approved insulated stick. Failure to do so could result in injury or death.
During use at voltages above 300 V, the entire Hotstick Unit should be consid-
ered energized. Do not let the Hotstick Unit or universal fitting touch any
grounded contact point. For 15 kV and below, maintain minimum 3” clearance
between the Hotstick Unit and ground. Above 15 kV maintain a minimum of 5”
clearance. A ground contact will damage the Hotstick Unit and could cause in-
jury.
