
1. Before installation, please cut off the power.
2. Remove old fixture if necessary for installation.
3. Connect line voltage (hot) AC supply wire(s) (Black) to the line voltage AC
wire(s) (Black) inside the canopy via the wire connector.
4. Connect neutral (common) AC supply wire(s) (White) to the neutral AC
wire(s) (White) inside the canopy via the wire connector.
5. Connect the grounded AC supply wire(s) [Green or bare wire(s)] to the
grounded AC wire(s) [bare copper wire(s)] using the wire connector.
6. Cap and insulate all unused leads.
7. To aim the light, loosen the side bolt connected to the knuckle arm to aim
the fixture up or down. Re-tighten bolt to secure the fixture in the desired
position.
WARNING: PROPOSITION 65
WARNING
Handling the coated electrical wires of this product can expose you to
chemicals including lead, which is known to the State of California to cause
cancer and/or birth defects or other reproductive harm. For more information
go to www. P65Warnings.ca.gov.
Read all of these installation instructions before installing the fixture. These
products may represent a possible shock or fire hazard if improperly installed
or attached in any way. Products should be installed by a qualified electrician
in accordance with these instructions, current local electrical code or the
current National Electric Code (NEC).
1. This product must be installed by a person familiar with the construction and
operation of the product and the hazards involved, and in accordance with
current electrical codes and/or the current National Electric Code (NEC).
2. To reduce the possibility of electric shock, fixture must be grounded.
3. Do not attempt to open the LED light engine.
4. Do not look directly into fixture.
5. The lamps must be used within the specified voltage range;
INSTRUCTIONS
01