24
When using this unit for the first time
First of all, try playing the preset sample movie.
fig.front01.eps
1
First, power on the display connected to this unit, then press the POWER
button of the RG-100.
* Once the connections have been completed (p. 20), turn on power to your various devices in
the order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
* This unit is equipped with a protection circuit. A brief interval (a few seconds) after power
up is required before the unit will operate normally.
* Be sure to check the following before powering on your equipment.
• Is the unit properly connected with other external devices?
• Are the volumes of this unit and other audio equipment turned down?
The STANDBY indicator lights in blue, and the unit prepares itself for startup.
It takes some time for the unit to start up (“Load” appears in the display on the front
panel). After startup is completed, the unit automatically plays back the sample
movie. The current time appears in the display on the front panel.
2
Power up the audio equipment connected to this unit.
3
Adjust the audio volume using the OUTPUT knobs of this unit and the volume
controls of other connected audio equipment.
4
Press the MANUAL MOVIE PLAY (1 – 8) buttons to select other movies to
play.
You can press a MANUAL MOVIE PLAY button (1 – 8) that is lit in orange to play
the movie of the selected number. While the movie is playing back, the
corresponding number button flashes.
5
Power off the unit.
1.
Press and hold the SHUTDOWN button for more than 2 seconds.
The SHUTDOWN indicator flashes alternately in red and green (during
shutdown process).
After a while, the display turns off, and the SHUTDOWN indicator lights in red
(standby mode).
2.
Press the POWER button.
The SHUTDOWN indicator turns off.
SHUTDOWN button/STANDBY indicator
POWER button
MANUAL MOVIE PLAY buttons
OUTPUT knob
For instructions on how to
adjust the time, refer to
When you press the MANUAL
MOVIE PLAY button that is
not lit, the black display
appears.
When the SHUTDOWN
indicator lights in red, the unit
is in standby mode and not
powered off. To power down
the unit completely, press the
POWER button, and the
SHUTDOWN indicator turns
off too.
000RG-100.book 24 ページ ２００４年８月６日 金曜日 午後５時３７分
