87
Practical Use of the PR-80
4.
Choose the operation you want to carry out at the set time.
• "Play":
Begins playback at the specified time.
• "Stop":
Stops playback at the specified time.
• "Shutdown":
Shuts down the PR-80 at the specified time.
• "Reboot":
Restarts the PR-80 at the specified time.
• "Time Adj":
Accesses the time server over the network at the specified time and corrects the
time setting.
5.
If you selected "Play," then choose the clip to play back.
Select the palette, then select the clip.
Making the Loop mode setting for the clips (p. 74) lets you program a clip sequence and have it
played back at any time you like.
6.
Clicking the [Save] button saves the settings.
Clicking the [Close] button lets you close the screen without saving the settings. If you modified the
schedule settings, however, a dialog box appears and prompts you to save the changes. To quit
without saving the schedule settings, click "Don't save."
Deleting a Schedule
At the "Schedule Editor" screen, choose the schedule you want to delete, then go to the lower left of
the "Schedule Editor" screen and click the [Delete] button.
Activating Scheduler
1.
Click the [Scheduler] button at the bottom of the “Schedule Editor” screen to highlight it in
orange.
The Scheduler function is switched on. The selected operation is then carried out at the time specified
in the settings.
The Scheduler's operational mode is indicated by the manner in which the “Clock” button lights.
Schedules set in Scheduler and Scheduler On/Off settings can be saved individually to different
projects. Scheduler is stopped when the Selector screen is active (with no project being opened). You
cannot play back and stop clips with Scheduler when Presenter is in Edit mode.
Time Resolution (Granularity) of the Scheduler
The time resolution, or granularity, of the Scheduler is in one-minute units. Because the Presenter
itself also experiences a certain amount of latency (delayed response), accuracy in units of seconds
cannot be assured.
Accuracy of the Internal Clock
The unit has a built-in clock for Scheduler operations. This clock is intended for use with a time server
(see p. 115 of the PR-80 Owner's Manual). The internal clock cannot be expected to keep accurate time
if the PR-80 is used alone.
Also, synchronization with a time server should be performed as frequently as possible using the
Scheduler. It is recommended that a time synchronization event be performed before a scheduled
event.
PR-80_e.book 87 ページ ２００５年１月６日 木曜日 午後９時２２分
