36
Introduction to Use of the PR-80
r. Audio Settings Panel
1.
Volume Level Meter
This indicates the volume level.
2.
[Audio] Slider
This adjusts the volume during audio playback.You can reset to standard values by clicking the
triangle at the position corresponding to the standard value.
You can also adjust the volume for each clip independently (p. 75).
s. [Playback Speed] Slider
You can alter the playback speed. You can also change the range of speeds permitted in the MIDI
preferences (p. 88). You can reset to standard values by clicking the triangle at the position
corresponding to the standard value.
t. [Effect] Buttons
These let you apply effects to video. There are four Effect buttons, allowing you to use four effects
simultaneously by switching them all on. For more details about working with this, refer to "Effects"
(p. 54).
u. [Defaults] Button
Restores the three sliders to the standard values. The standard settings are shown below.
You can reset the sliders to standard values by clicking the triangle at the position corresponding to
the standard value.
v. Palette Area
Displayed here are thumbnails of the clips contained in the palette and their settings. Clicking on a
thumbnail starts playback of the clip, and the video images are displayed in the monitor.
Also displayed are the clips’ Loop playback settings.
fig.play.clip01.eps
v-1. Keyboard identifier used when a clip is played back with the keyboard (p. 50).
v-2. Loop Mode setting, set separately for each individual clip (p. 74).
v-3. Length of clip from the In point to the Out point.
[Transition Effect Time] Slider
0.0 sec.
Effect buttons
OFF
[Audio] Slider
0 dB
Color Correction
INIT
[Playback Speed] Slider
100%
T-bar slider
(in the Dual Stream mode)
MAIN video 100%
Playback stops at the final frame
or the out point.
The next clip is selected.
Clip plays repeatedly.
The specified clip is played back.
The next clip is played back.
v-2
v-1
v-3
PR-80_e.book 36 ページ ２００５年１月６日 木曜日 午後９時２２分
