107
Practical Use of the PR-80
Controlling the V-4
Using an optional V-4, you can handle video input from an external device connected to the V-4 as
PR-80 clips. Additionally, you can use an external MIDI device to control the V-4’s effect settings and
fade the final video output.
Connect a USB MIDI interface to the PR-80, connect the MIDI interface’s MIDI OUT to the V-4’s MIDI
IN with a MIDI cable, and connect the PR-80’s OUTPUT connector to [INPUT 4] on the V-4.
First turn on the power to the V-4, then turn on the PR-80. Assign Mix01 to the V-4 MEMORY 8 MIX
button. When controlling the setup from the PR-80, bring the V-4’s video fader to the Channel A side.
1.
Set the Device ID for the V-4.
For instructions on how to set the Device ID, refer to the V-4 Owner’s Manual.
2.
If you're in the Play mode, click the [Preferences] button and then the [MIDI Preferences]
button. If you're in the Edit mode, click the [Preferences] button.
3.
Set the “V-4 Control” Device ID with “Device ID.”
Match this to the V-4’s Device ID.
fig.midi16.eps
When set to Broadcast, control messages can be transmitted, regardless of the slave device's settings.
4.
Check the “V-4 Control” check box.
The V-4 Control function is enabled.
fig.midi17.eps
Select a Device ID
Mark the checkbox
PR-80_e.book 107 ページ ２００５年１月６日 木曜日 午後９時２２分
