76
Use MIDI functionality
■
Inputting channel/block data
If a system exclusive message includes a channel or GS block number, here’s how to specify the
type and the value of the upper bits. For the channel and block number, the setting of the
current channel
will be inserted as the lower bits. (The block number is not actually a channel,
but corresponds to the “part” within a GS sound module. On the PCR-M30/50/80, this
corresponds to the channel for the sake of convenience.)
For an actual example, refer to
Bend Pitch Control
(p. 79) in the section on the Edit Mode.
1.
Press the
[DATA]
key several times at the location where you want to input the channel/
block number, to select “0CH” for the channel or “0BL” for the block.
fig.chbl
2.
Use the
[0]
-
[7]
keys to input the value of the upper four bits.
The “0” in the display will change to the numerical value that you input.
3.
Press the
[ENTER]
button.
Current channel
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
CH
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
BL
1
2
3
4
5
6
7
8
9
0
A
B
C
D
E
F
[DATA]
[DATA]
[DATA]
[DATA]
*1 Reference
*1 The -- area displays the currently set value. If it has not been set, the default setting will be displayed. Even if you change the type or mode
of the MIDI message that is assigned, the default setting will be displayed. This will be lit if the value is the same as the currently set value,
or will blink if the value is different.
PCR-M30/50/80.book 76 ページ ２００５年１１月１０日 木曜日 午後２時４９分
