30
Getting Connected and Installing Drivers (Macintosh)
Make the following settings so that you can use the MIDI functionality of the
PCR-M30/50/80. For a connection diagram, refer to
1
Use the USB cable to connect the PCR-M30/50/80 to your computer.
1.
With the power switch turned
OFF
, connect the
AC adaptor
to the
PCR-M30/50/80
.
2.
Connect the
AC adaptor
to an electrical outlet.
3.
Use the
USB cable
to connect the
PCR-M30/50/80
to your computer.
2
Set the PCR-M30/50/80’s
power switch
to the
ON
(DC) position.
3
Open the
Applications
folder of your Macintosh hard disk. In the
Utilities
folder, double-click
Audio MIDI Setup
to open the
Audio MIDI Setup
.
fig.osx2a-e
4
Click the
MIDI Devices
tab.
5
Click
“Add Device”
four times.
Four
new external MIDI devices
will appear.
6
Specify a name for each
new external device
.
1.
Click
Show Info
.
2.
Enter the name in the
Device Name
field.
Enter the following for
each
new external
device
.
Mac OS settings
First
Second
Third
Fourth
Device Name
PCR MIDI IN, OUT
PCR
PCR 1
PCR 2
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
Connect the cable to the
USB connector of the
Macintosh itself, not to the
USB connector of the
keyboard.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
4
6
5
Click MIDI Devices
Click Add Dvice
Click Show Info
For details on MIDI device
settings, refer to the
owner’s manual for the
software you are using.
PCR-M30/50/80.book 30 ページ ２００５年１１月１０日 木曜日 午後２時４９分
