Edirol PCR-A30, Owner'S Manual

Page: 37 / 112

37
Basic use
■
MIDI flow
●
When using a MIDI connection
fig.connect-out
fig.flow-MIDI1
As seen from the PCR-A30, each section in the diagram will be as follows.
* If you want to use the PCR-A30 as a MIDI keyboard, don’t connect the USB cable.
* For details on the actual operation, refer to “Using the PCR-A30 as a MIDI
keyboard” (p. 43).
●
When using a USB connection
fig.connect-usb
fig.flow-usb
* For an explanation of the items in the diagram,
refer to
“Input/output devices”
(p. 38).
* If V-LINK is ON, PORT 1 and PORT 2
messages will be sent both to USB and to the
MIDI connector.(
➔
“V-LINK mode”
(p. 81))
* For details on the actual operation, refer
to
“Using the PCR-A30 as a MIDI
controller” (p. 51).
BULK RECEPTION BULK data is received here
PORT 1 Of the keyboard, bender lever, and other controllers, those
that have been set to PORT 1 will transmit data from here
PORT 2 Of the keyboard, bender lever, and other controllers, those
that have been set to PORT 2 will transmit data from here
BULK TRANSMISSION BULK data is transmitted from here
AC adaptor
MIDI OUT
MIDI IN
MIDI sound module
(sold separately)
PCR-A30
MIDI OUT
MIDI IN
PORT 1
PORT 2 /
BULK RECEPTION
BULK TRANSMISSION
PCR-A30
MIDI OUT
MIDI IN
PORT 1
PORT 2 /
BULK RECEPTION
BULK TRANSMISSION
USB cable
AC adaptor
It is not necessary to connect the AC adaptor if
you are using a USB connection. However, with
some computers, the PCR-A30 may not operate
when powered from the USB bus. In this case,
set the power switch to the DC position and
connect the AC adaptor.
PCR-A30 PC
USB
EDIROL PCR-A
EDIROL PCR-A MIDI OUT
EDIROL PCR 2
EDIROL PCR-A 1
EDIROL PCR-A MIDI IN
MIDI OUT
MIDI IN
V-LINK OFF
PORT 1
PORT 2 /
MIDI OUT DEVICE
MIDI IN DEVICE
BULK RECEPTION
BULK TRANSMISSION
PCR-A30_e2.book 37 ページ ２００３年１０月２２日 水曜日 午後３時１９分