28
Getting Connected and Installing Drivers (Macintosh)
■
Setting the driver
If you are using FreeMIDI, proceed to
OMS settings
1
Use the following procedure to connect the PCR-A30 to your computer.
1.
With the
power switch
turned
OFF
, connect the included
AC adaptor
to the
PCR-A30
.
2.
Connect the
AC adaptor
to an electrical outlet.
3.
Use the
USB cable
to connect the
PCR-A30
to your
computer
.
2
Set the PCR-A30’s power switch to the
“DC”
position, and turn on the
power.
fig.3-3
3
From the CD-ROM, drag the
Driver E (Mac OS 9) - OMS
Setting
folder into the
Opcode - OMS Applications
folder on the hard disk of your Macintosh to copy it there.
fig.3-4
4
In the
Opcode - OMS Applications
folder where you
installed OMS, double-click
OMS Setup
to start it up.
fig.3-5_35
5
If a dialog box like the one shown
here appears, click
[Turn It Off]
. A
confirmation dialog box will then
appear, so click
[OK]
.
fig.3-6_35
6
The
Create a New Studio Setup
dialog box will appear. Click
[Cancel]
.
If you accidentally clicked
[OK]
, click
[Cancel]
in the next screen.
Once the connections have
been completed, turn on
power to your various
devices in the order
specified. By turning on
devices in the wrong
order, you risk causing
malfunction and/or
damage to speakers and
other devices.
This unit is equipped with
a protection circuit. A brief
interval (a few seconds)
after power up is required
before the unit will operate
normally.
We recommend that you
turn off
AppleTalk
, by
selecting Chooser from the
Apple menu.
If you are using the PCR-
A30 in conjunction with
other MIDI devices, make
settings as described in
ReadmeE.htm
located in
the
Driver E (Mac OS 9)
folder of the CD-ROM.
PCR-A30_e2.book 28 ページ ２００３年１０月２２日 水曜日 午後３時１９分
