27
III.
Pair Button
Your gateway unit and camera unit and wirelessly paired at the factory and
manual pairing is not necessary. However if you need to re-pair your units for
some reason, or if you accidently clear the existing pairing, follow the
instructions below. The pair/reset button will clear existing pairings when
pressed for 5 seconds.
Your gateway unit and camera unit and already paired when you
purchase them and under normal circumstances no manual pairing is
necessary.
1.
Push the
Pair
button on the gateway unit for 5 seconds to activate pairing.
After quickly flash of Power Led for 5 seconds, press the
Pair
button on the
gateway again.
2.
Within 30 seconds, push the
Pair
button on the camera unit for 2 seconds.
After a few seconds, the camera’s
Status
LED will flash quickly
orange
to
indicate successful pairing.
